Audio Control; Connect Audio; Mute/Unmute; Media Channel - Grandstream Networks IPVT10 User Manual

The Chatting feature is only available for panelists group.
b)
If the scheduled Webinar is set to record automatically, this recording feature will be started only
c)
if the Webinar starts.
Note: If the Webinar is about to the scheduled ending time, but the Webinar is not started, this Webinar will
be expired automatically.

Audio Control

Connect Audio

By default, most of the mobile devices should already have built-in microphone/speaker to support audio in
the meeting, without additional audio devices connected.

Mute/Unmute

•
Click the microphone icon on participants list to mute the user, and the icon will turn to
•
Click again to unmute the microphone, and the icon will change back to
muted by the meeting host, the MIC icon will be
unmute himself/herself, only the meeting host can unmute the participant. To apply to unmute the
MIC in the meeting, the participant could click to raise hand to indicate the meeting host.

Media Channel

When users join into the meeting, users could set the media channel manually.
Users could click on button
1.
the figure shows below.
If users have the Bluetooth headset connected with the device, the media channel will be selected as
2.
"Bluetooth Headset". Otherwise, the media channel is "Speaker" as default.
If users have a new 3.5mm headset or Bluetooth headset connected with the device, the media
3.
channel will be switched to use the new media device.
If users disconnect the 3.5mm headset or Bluetooth headset, the media channel will be switched to
4.
use other 3.5mm headset or Bluetooth headset as default. Otherwise, the media channel will be
switched to "Speaker".
Users can adjust the volume on the mobile device.
. At this time, the participant cannot
to open the configuration interface, and select the media channel as
IPVT10 User Guide
Version 1.0.2.8
.
. If the participant is
P a g e | 97