Table of Contents
Advertisement
3
Moving the truck with the drive unit inoperative
f
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failure has rendered it immobile, proceed as fol-
lows:
– Ensure that the truck cannot accidentally move.
– Set the master switch to position "OFF".
– Set the key switch to position "OFF" ("0") and remove the key.
– Unlock the cover locks (2), open and set down the front hood (3).
– Slacken the lock nuts (4) and tighten the
screws (5).
The brake has now been released and the
truck can be moved.
f
After arriving at the repair bay, ensure that
the brake is put back to its initial state. The
truck must on no account be parked with the
brake in the released condition.
– Loosen the screws (5) by approx. 5 mm
and lock by tightening the lock nuts (4).
The brake is now applied again.
2
3
C 2
5
4
Advertisement
Table of Contents
