Moving The Truck With The Drive Unit Inoperative; Towing The Truck - Jungheinrich EFG-Vac 22 Operating Instructions Manual

3

Moving the truck with the drive unit inoperative

In order to move the truck without
electricity supply, the spring-loaded
brake must be disengages as follows:
– Set lever (1) to position "Disengage
spring-loaded brake".
– Turn the steering wheel clockwise
until pressure builds up in the
hydraulics circuit and the spring-
loaded brake is disengaged. (This can
be noticed by checking whether the
brake pedal functions normally, if the
brake is still engaged you feel an
immediate resistance). The drive
wheels are no longer blocked resp.
decelerated by the spring-loaded
brake. The foot brake will still be fully
operative. While turning the steering
wheel the foot brake must not be
actuated.
f
Before the driver leaves the truck with the spring-loaded brake disengaged he must
secure the truck against accidental rolling away.
m
Prior to recommissioning the truck by applying power again, lever (1) must be set to
the right to "Travel position". The truck is now ready to operate in travel position.
4

Towing the truck

– Connect a tow-rod/towing rope at the trailer coupling of the recovery vehicle and at
the truck to be towed.
– Disconnect the battery plug (observe item 3!).
– Disengage the parking brake.
f
There must be a person for steering the truck on the driver seat of the truck to be
towed. Tow the truck at walking speed!
A
As the steering booster is not switched on, the truck can only be steered with
increased effort.
1
C 3