Manual Scan - Pioneer PDP-507XDA Operating Instructions Manual

09 Enjoying DTV broadcasts
6 Select "Yes" to start "Auto Scan" (/ then ENTER).
• The tuner starts scanning from channel 6 to channel 69. The
percentage bar shows the progress.
Scan Status
9/69
Scan Percentage
Signal Strength
• If any new channel is found, it is automatically registered on
the plasma display.
001
002
003
004
005
006
Scan Status
Scan Percentage
Signal Strength
• To quit a channel scan in progress, press RETURN. If you
quit scanning halfway, all channels may not be registered
properly. Make sure to repeat scanning again until it is
completed.
Note
• You can select "DTV Setup" only while viewing DTV channels.
• Once the digital TV signal is scanned, the channel number and
programme name will be shown on the Programme List above
the percentage bar.

Manual Scan

This function is used to add channels to the preset channel list
when a new channel is added to the city or region you live in.
Manual Scan searches for the channel based on the frequency and
bandwidth you request.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "DTV Setup" (/ then ENTER).
4 Select "Installation" (/ then ENTER).
• The password entry screen appears. Enter your 4-digit
password using buttons 0 to 9.
42
En
0%
Channel 9 found...
9/69
0%
5 Select "Manual Scan" (/ then ENTER).
• A scanning data entry screen appears.
Channel No.:
Frequency : 198500 KHz
Bandwidth : 7 MHz
Signal Level
Quality
SNR
Start Scan
6 Select "Channel No." (/).
7 Select the RF Channel No. you want to scan (/).
• If you enter the correct RF Channel No., the correct
frequency displays. If the correct frequency is not displayed,
check the RF Channel No. you have entered.
8 After entering the correct RF Channel No., select "Start
Scan" (/ then ENTER).
• Scanning starts for the designated RF channel.
Channel No.:
Frequency : 198500 KHz
Bandwidth : 7 MHz
Signal Level
Quality
SNR 26 dB
Get Channel Success
• When scanning is completed, the image on the scanned
channel is displayed.
• If scanning fails and no screen appears, you can try to scan the
signal again, or refer to the Signal Level and Quality indicators
to align the antenna to improve your signal reception.
• To quit a channel scan in progress, press RETURN.
Note
• You can select "DTV Setup" only while viewing DTV channels.
9
100%
100%
dB
9
100%
100%