GDD Instrumentation MPP-EM2S Plus Instruction Manual page 32

11.2 Continuous mode
In this mode, the readings are recorded automatically according to the recording frequency you need
(every second, every five seconds, etc.). Marking different positions along the core sample will help
you to have a more accurate graphic.
Needed settings (Reading page in the configuration-CFG menu):
Space, Depth, Unit, Recording frequency.
How to use:
1
2
3
1: Spacing button
This button indicates the activated spacing. If more than one spacing has been configured in the
three boxes of the parameter (Section 10.1), it is possible to switch between the spacings by
clicking on this button.
2: Depth field
This field shows the depth where the next point must be marked (stamp button). For irregular
distances between the readings, it is possible to set the distance manually before each marking by
writing the depth in this field by using the keyboard.
Instrumentation GDD Inc.
6
5
4
Keyboard
2018-01-16
Marking Memory
button
(STAMP)
button
(MEM)
31