Installation Guide - Rize Contemporary III Owner's Manual

Installation Guide

NOTE:
For safety reasons, lifting of the adjustable bed frame must always be performed by two
(2) people; and the unit should always be on a flat surface before opening.
Setting up your adjustable bed frame
FOR TWIN, TXL, SQ, SCK, FULL, AND FXL MODELS
1
Lift the bed frame unit out of the shipping carton carefully, and
put it on a flat floor with the top side facing downward.
2
Remove all accessory boxes and cut the orange ties from inside
the bed frame.
FOR QN, KING, AND CAL KING MODELS
1
Lift the two separate sections of the bed frame out of the
shipping carton carefully, and put them on a flat floor with the
top side facing downward.
2 Remove all accessory boxes and cut the orange ties from inside
the bed frame.
3
Move the head and foot sections of the bed together. Make
sure the bars and frames are properly aligned at the center.
4
To connect the head and foot sections, put the center leg
bracket over the parallel bars, lining it up with the pre-drilled
holes.
5
Thread the screw through the center leg bracket and into the
bars to keep it in place. Thread a nut at the end of the screw,
and tighten it with a wrench.
6
Repeat steps 4 and 5 on the other end of the parallel bars.
6