Rize Aviada Remote Programming Instructions

How to Sync Two Beds to one remote

Each Aviada adjustable bed arrives pre-programmed to the remote that comes with it. If you want to
operate two bases together, you must pair both to one remote. Make sure your first adjustable base is
plugged in, then Please follow the steps below to complete the pairing:
learn button
LED Light
programmable
presets
Note: for safety reasons the anti-snore and flat buttons cannot be reprogrammed.
Step 3: The new position will override the default setting on the button you chose. To restore the bed's
default settings, please see the next page.
Rize
Programming instructions
Step 1: Insert batteries into the remote control you want to use
(Use Three AAA batteries - Included).
Step 2: Plug the second adjustable base into a working grounded
outlet. A surge protector is recommended.
Step 3: Locate the control box. Hold down the learn button for
three seconds.
Step 4: The LED light will blink and then turn off.
Step 5: on the remote, Press and hold the "flat" and massage "stop"
Flat Button
buttons for four seconds.
Stop Button
Step 6: the LED light on the control box will blink and then remain
on. Both bases will now operate together using one remote.

How to program your own positions

The Aviada comes with four preset positions: incline, anti-Snore,
Lounge, and zero gravity. You can also create a custom position
by saving over one of the presets. Follow these instructions:
Step 1: move the bed into the desired position.
Step 2: press and hold the "program" button & one of the available
preset buttons (Incline, Lounge, or Zero Gravity) for three seconds.
®
Aviada remote