Rize Contemporary III Owner's Manual page 7

Installation Guide
Attaching the bed legs
1
Take out the lounger bed legs and post bed legs from the
accessory box.
2
Attach the post bed leg to the end of the lounger bed leg by
threading it in a clockwise direction.
NOTE: If you want to add more height to the bed frame, attach
the leg extenders between the lounger bed leg and the post
bed leg.
3
Attach the lounger bed leg to the C-channel frame in the foot
section of the bed. Make sure the leg opening is facing inside
the frame.
4
Insert a knob screw fitted with a washer into the pre-drilled
hole in the C-channel frame and through the lounger bed leg.
Tighten the knob screw in place.
5
Repeat steps 2, 3, and 4 on the other lounger leg.
6
Attach the remaining post bed legs to the head section of the
bed by threading them clockwise into the pre-drilled holes.
NOTE:
If you want to add more height to the bed frame, attach
the leg extenders between the frame and the post bed leg.
7
Tighten the legs securely to the frame.
NOTES:
• Do not overtighten the bed legs.
• Make sure all legs are adjusted to the same height.
Setting up the electronics
FOR QN, KING, AND CAL KING MODELS
1
Plug the cord for the foot lift into the control box. Insert it into
the port labeled "Foot Actuator" (with red & orange label).
2
Plug the cord for the foot massage into the control box. Insert it
into the port labeled "Foot Vibration" (with blue label).
7