Reading The Plc Indicator Light - Devolo Magic 1 WiFi 2-1 Manual

Expanding an existing devolo Magic PLC network by
adding another devolo Magic adapter
In order to use a new devolo Magic 1 WiFi in your
devolo Magic- network, first you have to connect it to your
existing devolo Magic adapters devices as a network. This
is accomplished by using a shared PLC password, which
can be assigned in various ways:
Using devolo Cockpit or the devolo app (see Chapter
3.4 Installation of devolo software)
Using the web interface (see Chapter 4.5 Powerline)
Using the PLC button as described below.

To do so, plug the new devolo Magic adapter into an
available power socket and, for approximately
1 second, press the PLC button on a devolo Magic
adapter in your existing devolo Magic network.
For each pairing operation, only one additional
devolo Magic adapter can be added at a time.
LED Flashing
haviour
1 Red LED Lights up for up
to 2 sec.


2.3.1 Reading the PLC indicator light

The integrated PLC indicator light (LED) shows the status
for the devolo Magic 1 WiFi by illuminating and/or flas-
hing:
be- Meaning
Start-up process
Within 3 minutes, press the PLC button on the
devolo Magic adapter that you want to add to your
existing devolo Magic network. The LED of this adap-
ter now also flashes white.
After a short time, the flashing LED becomes a
steady white light. The devolo Magic adapter has
been successfully integrated into your existing
devolo Magic network.
You can find detailed information about installing
devolo Magic adapters in Chapter 3.3 Connecting
the devolo Magic 1 WiFi.
Introduction 14
LED status display
(web interface*)
Cannot be disabled
devolo Magic 1 WiFi