Operation With Other Devices; Maintenance - Schiller CARDIOVIT AT-1 G2 User Manual

CARDIOVIT AT-1 G2 User guide
1.8

Operation with other Devices

 Accessories connected to the analogue and/or digital interfaces must be certified
according to the corresponding IEC standards (e.g. IEC/EN 60950 for data
processing equipment and IEC/EN 60601-1 for medical equipment).
Furthermore, all configurations shall comply with the valid version of IEC/EN
60601-1. Everyone who connects additional equipment to the signal input part or
signal output part configures a medical system and is therefore responsible that
the system complies with the requirements of the valid version of IEC/EN 60601-
1. If in doubt, contact the technical service department or your local
representative.
 Any other equipment used with the patient must use the same common earth as
the CARDIOVIT AT-1 G2.
 Special care must be exercised when the unit is used with high-frequency
equipment. Use the special high frequency SCHILLER patient cable to avoid
possible signal interference during ECG acquisition. However, the stimulation
units should only be used at a sufficient distance from the electrodes and both
devices must be connected to the same potential equalisation. If in doubt, the
patient should be disconnected from the device.
 There is no danger for patients with a pacemaker.
 There is no danger when using this unit simultaneously with electrical stimulation
equipment.
 If the patient cable should become defective after defibrillation, a lead-off
indication is displayed on the screen (see
 Portable communication devices, HF radios and devices labelled with the
symbol (non-ionic electromagnetic radiation) can affect the operation of this
device (page
1.9

Maintenance

 Danger of electric shock. Do not open the device. There are no serviceable parts
inside. Servicing must only be performed by qualified technicians authorised by
SCHILLER.
 Before cleaning and to isolate the mains power supply, switch the monitor off and
disconnect it from the mains by removing the plug.
 Do not use high-temperature sterilisation processes (such as autoclaving). Do
not use e-beam or gamma radiation sterilisation.
 Do not use aggressive or abrasive cleaners.
 Do not, under any circumstances, immerse the unit or cable assemblies in liquid.
Operation with other Devices
54).
Safety notes
page 25).
1
1.8
Page 9