Adjusting The Seat Depth Without Replacing The Seat Support Plate - Invacare Storm 4 Series User Manual

Invacare® Storm®⁴ Series
Holes used
Seat in front seat
depth frame order
in cm no.: 1524550
48 2 & 4
51
1 & 3
53 1 & 2
2. Adjust the seat depth as described in the following
chapter:
- If the seat support plate does not need to be replaced,
please refer to chapter 5.16.3 Adjusting the seat depth
without replacing the seat support plate, page 66.
- If the seat support plate does need to be replaced,
please refer to chapter 5.16.4 Adjusting the seat depth
with replacing the seat support plate, page 67.
66
Holes used Seat
in rear seat support
frame order plate
no.: 1524555 required
A & C LONG
order no.
A & C
1526439
B & C
5.16.3 Adjusting the seat depth without replacing the
seat support plate
Fig. 5-3 Exploded drawing of seat support
Disassembly
1. Remove the armrests.
2. Remove the seat cushion.
3. Remove the cover plates (1).
4. Undo and remove the two Allen screws (8) which are
located on the side at the rear of the seat support plate,
and connect these to the crossmembers (4).
5. Repeat these operations on the other side of the seat.
6. Undo and remove the two Allen screws (5) including
washers.
1529686-U