Adjusting The Seat Depth Without Replacing The Seat Support Plate - Invacare Storm4 X-plore User Manual

• Adjust the seat depth as described in the following chapter:
- If the seat support plate does not need to be replaced, please refer to Chapter 9.12.2.2.
- If the seat support plate does need to be replaced, please refer to Chapter 9.12.2.3.

9.12.2.2 Adjusting the seat depth without replacing the seat support plate

• Remove the armrests.
• Remove the seat cushion.
• Remove the cover plates (1).
• Undo and remove the two Allen screws (8) which are located on the side at the rear of the seat
support plate, and connect these to the crossmembers (4).
• Repeat these operations on the other side of the seat.
• Undo and remove the two Allen screws (5) including washers.
Assembly:
• Pull the seat support to the required length so that the Allen screws (5) can be inserted in the
holes in accordance with the table (see above).
• Insert the Allen screws (5) including washers again and tighten them.
• Fit the two Allen screws (8) which are located at the rear of the seat support, and connect them
with the crossmembers (4). You must be using other holes within the 3 hole pairs for the
screws than you did during dismantling.
• Refit all the parts you have removed.
97