Replacing The Seat Support (Without Lifter Or Seat Angle Adjustment Modules) - Invacare Pronto M41 Series Service Manual

®
Invacare - PRONTO M41
8.9.2.6

Replacing the seat support (without lifter or seat angle adjustment modules)

Note
This chapter deals with replacing the seat support for a seat without lifter or seat angle
adjustment modules. Please proceed as described in chapter 8.9.2.4 to replace lifter or seat
angle adjustment modules.
CAUTION: Risk of crushing!
The seat is very heavy. Injury hazard to hands and feet!
● Pay attention to the hand and feet
● Use proper lifting techniques
Requirements:
● 3 mm Allen key
● 10 mm open-ended wrench
● T25 Torx wrench
● T40 Torx wrench
● Side cutting pliers
● Cable ties
• Remove legrests.
• Switch the electronics OFF on the remote.
• Remove the backrest cushion.
• Loosen and remove the screws, which secure
the middle seat plate (A) with a 3 mm Allen key.
• Remove the middle seat plate (B).
• Loosen and remove the screws on both sides,
which secure the lateral seat plates (C) with a
3 mm Allen key.
• Remove the lateral seat plates (D).
or
• Remove the seat cushion.
• Loosen and remove the screws on both sides,
which secure the sling seat (A) with a
T25 Torx wrench.
• Remove the sling seat (B).
SERVICE MANUAL
75