Adjusting Depth
1. Loosen screw A.
2. Adjust rod to desired depth.
3. Tighten screw.
Adjusting Position
The swing-away mechanism can be turned through 360
degrees.
1. Loosen screw A.
2. Adjust to desired position.
3. Tighten screw.
5.7 Adjusting Powered Chin Control
CAUTION!
Risk of Injury and Damage
Remaining burrs and missing end caps after
modifications on rods, such as shortened rod, can
lead to injury or damage.
– Deburr cut after cutting excessive length.
– Re-install end cap after deburring.
1529686-U
5.7.1 Adjusting Extremity Control Joystick
See "Adjusting Joystick Orientation" in 5.6.1 Adjusting
Extremity Control Joystick, page 41.
5.7.2 Adjusting Joysticks and Switches on Linkage
Positioning Joysticks / Switches
Risk of damage to screws
If you tighten screws to an improper torque, they
might either come loose or get damaged.
– Tighten the screws to a torque of 3 Nm ± 10 %.
•
4 mm Allen key
1. Loosen screws A.
2. Move joystick or switch to desired position on the
linkage.
3. Tighten screws.
Setup
43