Table of Contents
Advertisement
Invacare® Storm®⁴ Series
7. Remove the cover plates (1).
8. Undo the two Allen screws (9) at the front on the seat
support plate and remove them.
9. Undo the two Allen screws (7) which are located on the
side at the front of the seat support plate, and connect
these to the crossmembers (4).
10. Undo the two Allen screws (8) which are located on the
side at the rear of the seat support plate, and connect
these to the crossmembers (4).
11. Remove the seat support plate (2).
12. Repeat these operations on the other side of the seat.
13. Undo and remove the two Allen screws (5) including
washers.
Assembly
1. Pull the seat support to the required length so that
the Allen screws (5) can be inserted in the holes in
accordance with the table (see above).
2. Insert the Allen screws (5) including washers again and
tighten them.
3. If necessary, replace the seat support plate (2) in
accordance with the table (see above).
4. Put the seat support plate (2) back in position.
5. Fit the two Allen screws (7) which are located at the
front of the seat support, and connect them with the
crossmembers (4).
6. Fit the two Allen screws (8) which are located at the
rear of the seat support, and connect them with the
crossmembers (4). It may be necessary to use other
holes in the 3 hole pairs for the screws than you did
while dismantling the old plate.
68
7. Fit the two Allen screws (9) at the front of the seat
support plate.
8. Refit all the parts you have removed.
5.17 Backrest unit with ergonomic length
compensation (Easy-Adapt)
5.17.1 Adjusting the width
Also refer to the previous chapter entitled 5.16.1
Adjusting seat width, page 64.
The seat can be adjusted in stages between 380 and
530 mm.
Tools:
•
4 mm Allen key
1. Remove the backrest cushion.
2. Loosen the three Allen screws (1). Do not, however,
remove these screws completely.
1529686-U
Advertisement
Table of Contents
