UP3D TECH CO.,LTD
A3. Check if it needs to add scan after it is scanned (editable),if not, click【Apply】
(4) Automatic alignment: wax-up alignment
(5) T
he order scanning is finished
4.4.6
Freedom scan
(1)Create an order
A1. Create an order,select the tooth position and define a design type
A2. Select the following scan options and start scanning
Design type: Freedom scan
(2)Observe side scan
A1. Follow the instructions of the scanning guide then insert the front of the object
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after it is scanned (editable),if not, click【Apply】
(3)Reverse side scan
A1. Follow the instructions of the scanning guide then insert the object on the opposite side
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after it is scanned (editable),if not, click【Apply】
(4) Automatic alignment: freedom scan alignment
(5) The order scanning is finished
61