UP3D UP500 User Manual page 59

UP3D TECH CO.,LTD
Occlusion: none;
Adjacent tooth scan: sectioned model
（2）Model scan
A1. Follow the instructions of the scanning guide then insert the model
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the model is scanned (editable),if not, click【Apply】
（3）Wax-up bridge scan
A1. Follow the instructions of the scanning guide then insert the wax-up bridge
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the wax-up bridge is scanned (editable),if not, click
【Apply】
（4）Dies scan
A1. Follow the instructions of the scanning guide then insert the dies
A2. Click【Next】/【Enter】to scan
A3. Check if it needs to add scan after the dies is scanned (editable),if not, click【Apply】
(5) Automatic alignment including: die and wax-up alignment
(6) The order scanning is finished
Gypsum model, sectioned, mixed wax-up: both single tooth wax-up and wax-up bridge
4.4.5.3
(take no antagonist for example)
（1）Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Design type: wax-up (whether bridge or not)
Model source: model
Occlusion: none
Adjacent tooth scan: sectioned model
（2）Model scan
A1. Follow the instructions of the scanning guide then insert the model
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the model is scanned (editable),if not, click【Apply】
59