UP3D UP500 User Manual page 60

UP3D TECH CO.,LTD
（3）Wax-up bridge scan
A1. Follow the instructions of the scanning guide then insert the wax-up bridge
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the wax-up bridge is scanned (editable),if not, click
【Apply】
（4）Dies scan
A1. Follow the instructions of the scanning guide then insert the dies
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the dies is scanned (editable),if not, click【Apply】
（5）Single wax-up scan (with multi-dies plate)
A1. Follow the instructions of the scanning guide then insert the single wax-up
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the single wax-up is scanned (editable),if not, click
【Apply】
(6) Automatic alignment including: dies and wax-up alignment
(7) The order scanning is finished
Gypsum model, unsectioned, single tooth wax-up/wax-up bridge/mixed wax-ups (take
4.4.5.4
no antagonist for example)
（1）Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Design type: wax-up (whether bridge or not)
Model source: model
Occlusion: none
Adjacent tooth scan: unsectioned model
（2）Model scan
A1. Follow the instructions of the scanning guide then insert the model
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the model is scanned (editable),if not, click【Apply】
（3）Wax-up scanning (whatever types)
A1. Follow the instructions of the scanning guide then put the wax-up
A2. Click【Next】/【Enter】to scan
60