UP3D UP500 User Manual page 50

UP3D TECH CO.,LTD
A3. You can do a one-point alignment or a 3-point alignment by selecting the percentage in the
fractional alignment when both of them fail.
100%: Align the entire model
75%: Model alignment from 75% below the occlusion
50%: Model alignment from 50% below the occlusion
25%: Model alignment from 25% below the occlusion
The alignment will be completed automatically if the selection is correct, a prompt
dialog box will pop up if no alignment is successful and you will re-select the point
for alignment after clicking OK
A4.The system prompts you to manually align and if the current alignment result is correct, you do
not need to manually align, you can click【Apply】to execute the current alignment result.
For the model needs to be manually selected for alignment, you can re-select the position by
clicking the [Reset Current] button when the position of the selected point is wrong or you can
directly move the point to another location or double-click the point, delete the point, and re-select
the point location.
It will enter status of all alignment completed after the alignment is successful and the alignment
result can be visually checked.
【Reset all】: It will cancel the result of automatic alignment and perform manual alignment after
clicking this button.
(8) Next, enter the export step and the order scanning is finished.
Figure4-9
50