UP3D UP500 User Manual page 48

UP3D TECH CO.,LTD
Application: need to scan the adjacent tooth relationship, the die has been sectioned and use the
multi-dies plate to scan.
Take the model with antagonist jaw (the antagonist jaw can be gypsum or wax-bite) for example to
introduce the scanning process.
（1）Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: model
Occlusion: antagonist
Adjacent teeth: sectioned model
Multi-die: activated
（2）Occlusion scanning
A1. Follow the instruction of the scanning guide to insert the Occlusion Model
A2. Click【Next】/【Enter】to scan
A3. Check if it needs to add scan after the occlusion model is scanned, if not, click【Apply】
（3）Jaw scan (working model)
A1. Follow the instruction of the scanning guide then insert the Working model. Please put the
upper jaw first if the upper and lower jaws are both working models.
A2. Click【Next】/【Enter】to scan
A3. Check if it needs to add scan after the jaw is scanned, if not, click【Apply】
Mark the tooth position on the working model (This step has been canceled in UPSCAN version
after 20180725)
Mark the tooth position on the occlusion surface according to the indication in the tooth diagram.
Marking order: clockwise
Operation:
A1. The direction of the model can be adjusted to be the same as the tooth position indication map
in order to facilitate the marking, there is a text prompt in the tooth diagram: please mark the XX
tooth position and an orange circle will be displayed on the corresponding tooth position;
A2.The tooth diagram will prompt the tooth positions to be marked one by one (refer to tooth
marking method) if there are multiple teeth positions to be marked
A3. Single click to mark the tooth position on the occlusal surface of the corresponding model tooth
position and the marker point will display blue. There will not prompt text in the tooth position
indication diagram after all the indicated teeth marks are completed, only the jaw will be displayed.
48