UP3D UP500 User Manual page 43

UP3D TECH CO.,LTD
A1.Click【Margin edit】to enable or disable the margin line generation and editing function.
A2.The software will display the tooth position indicator and the margin line panel when the
function is enabled.
A3.The tooth position diagram is used to select the tooth position, and the margin line is generated
or edited for different tooth positions. Click right button on the blank area of the tooth diagram,
which can display the right button menu, including the upper and lower jaw switching functions.
A4.The margin line panel is used to select the generation and editing functions.
A5.Generating margin line-【Traction detection】Function: Click to select a point as the starting
point (red point) at the margin line of the model of the current tooth position, click in the same
direction along the margin line to select margin line point (blue) until the last point meets with the
first point, then the margin line is generated. The margin line is connected in real time between
every two points. When the margin line is off the margin, the user can click to add a new point to
guide the margin line generation.
Generally only three points are needed to guide the generation of the margin line, no
need to add too many points
A6.Generate margin line-【Multi-points detection】function: select a point at the margin of the
model of the current tooth position. The margin line is automatically generated if the one-point
detection is successful. If the detection fails, add points in different areas of the margin and guide
the generation.
Multipoint detection is used by default. You must add three points to generate if
one-point detection fails.
A7. Display margin line: Show or hide the margin line of the current tooth position
A8. Display control points: show or hide the control points of the current tooth position
A9. Margin line editing
When the margin line is displayed in green, it means the current tooth position, the others will
display in blue.
43