UP3D UP500 User Manual page 56

UP3D TECH CO.,LTD
A2. Select the following scan options and start scanning
Model source: impression
Impression tray: double side
Occlusion: full arch
（2）Triple tray impression scan (working model facing upward)
A1. Follow the instructions of the scanning guide then insert the triple tray impression (working
model facing upward)
A2. Click【Next】/【Enter】to scan;
A3. Check if it needs to add scan after the impression is scanned (editable),if not, click【Apply】
（3）Opposite tray scan (non-working model facing upward)
A1. Follow the instructions of the scanning guide then insert the opposite tray (turn over the
impression tray and continue scanning);
A2.Click【Next】/【Enter】to scan;
A3.Check if it needs to add scan after the dental tray model is scanned(editable),if not, click
【Apply】
(4) Automatic alignment: occlusion alignment
(5) T
he order scanning is finished
Triple tray impression scanning (Partial arch, place it vertically)
4.4.3.4
Application: For scanning impressions that have not been turned into gypsum and the arch is a bit
short.
（1）Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: impression
Dental tray: double side
Dental arch: partial arch.
（2）Impression scan
A1. Follow the instructions of the scanning guide then insert the impression
A2.Click【Next】/【Enter】to scan;
A3.Check if it needs to add scan after the impression is scanned (editable),if not, click【Apply】
（3）Opposite tray scan
A1. No need to turn over the impression, just next (the scanning will automatically continue)
56