UP3D UP500 User Manual page 52

UP3D TECH CO.,LTD
Application: For that needs to scan the adjacent tooth relationship, but the die is not sectioned.
Take the model without antagonist jaw for example to introduce the scanning process.
（1）Create an order
A1. Create an order, select a tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: gypsum model
Occlusion: none
Adjacent teeth: unsectioned
(2) Jaw scan (refer to jaw scan)
(3) T
he order scanning is finished
4.4.2.4 Quarter model (all-in-one scanning)
Application: For that sectioned model with an incomplete arch and an antagonist jaw model.
（1）Create an order
A1. Create an order, select the tooth position and define a design type
A2. Select the following scan options and start scanning
Model source: Model
Occlusion:
Quadrant
Adjacent teeth: sectioned
（2）Quadrant model occlusion scan
A1.Follow the instruction of the scanning guide to put in quadrant occlusion model
A2.Click【Next】/【Enter】to scan;
A3.Check if it needs to be add scan after the occlusion model is scanned (editable),if not, click
【Apply】.
（3）All-in-one scanning
A1. Follow the instruction of the scanning guide to use an all-in-one plate then put in a quadrant
model and dies (upper jaw, lower jaw and dies on the plate)
A2.Click【Next】/【Enter】to scan
A3.Check if it needs to be re-scanned after the combined model scan is completed (editable),if not,
click【Apply】
(4) Mark the tooth position: mark the upper jaw, lower jaw and die according to the text prompts in
the application panel.
52