Instructions for kit #B 1895
□
a
27. Pull the bottom hinge pin to disassemble the door
for painting. Tape the pins under the threshold so you
don't lose them (a cut off of a paper clip can substitute
for a lost pin). Re-assemble the door when the painting
is done. Glue in the pane with a tiny dot of super-glue or
silicon glue in each corner.
Rafters
Turn the house up-side-down on several thicknesses of cardboard.
□
28A. Porch Rafter Ends: Lightly mark the underside of the
Porch Roof every 1
1
/
right. This will give you pairs of marks
the Porch Rafter Ends.
Glue the Porch Rafter Ends to the Roof and edge of the Porch
Beam. Use the Handy Square to keep them straight.
Porch Rafter End
□
28B. Arches: Glue Arches to the Posts and Porch Beam,
centered front-to-back in the notch.
" from right to left, then again from left to
2
3
/
" apart for locating
16
Porch Rafter End
Arch
page 20