Real Good Toys Beachside Bungalow Instructions Manual page 17

Instructions for kit #B 1895
□
18. Lay out the Front Roof and Porch Roof up-side-down.
Tape them together with the points of the bevels touching. Turn
them over and spread glue in the bevel where they touch. Without
glue, set the Front and Rear Roof on the housebody. Tape over
the top and thru the dormer cutout to hold the parts in position as
the glue dries.
□
19. When the glue is dry, remove the Roofs and take off the tape; spread glue on
the housebody and Porch Beam where the Roofs touched, and glue the Roofs back
in place. Inspect the fit side-to-side (1
fit with the Front Wall inside the Dormer hole.
Check the Porch Beam's position by holding a Porch Rafter against it on both ends.
The Rafters must fit the edge of the Porch Roof the same on both ends
(they do not have to line up with the edge - they do have to fit the same).
1 / "), and make sure the Roofs make a good
2
Step 19: Porch Rafters
fit the same on both ends
Tape
Inspect the fit here
Step 18: up-side-down
The points of the Bevels
are touching
Detail of the Roof's Bevels
right-side-up
Front
Porch Rafter
page 17