Table of Contents
Advertisement
User Manual for the
WPS Series Wireless Pressure Sensor
6.2.4 Tools required
•
#2 Phillips Screwdriver
•
Torque Screwdriver with #2 bit
, ATTENTION
Batteries must be replaced only by a trained service technician.
m WARNINGS
•
Risk of death or serious injury by explosion. Do not open sensor enclosure when an explosive gas atmosphere is present.
•
Batteries must not be changed in an explosive gas atmosphere.
•
The sensor enclosure must not be opened when an explosive gas atmosphere is present.
•
When not in use, the batteries must be stored in a non-hazardous area.
•
The batteries used in this device may present a risk of fire or chemical burn if mistreated. Do not recharge, disassemble,
heat above 100 °C [212 °F], or incinerate. Do not expose batteries to water.
•
When installing batteries do not snag the battery terminal on the clip or the battery may be damaged. Do not apply exces-
sive force.
•
Do not drop. Dropping the battery may cause damage. If a battery is dropped, do not install the dropped battery into the
sensor. Dispose of dropped battery promptly per local regulations or per the battery manufacturer's recommendations.
Figure 4. Sensor Battery Replacement
16
Honeywell Sensing and Control
ISSUE 1
Should we include warn-
ing that batteries must be
replaced at the same time?
50095584
Advertisement
Table of Contents
