Honeywell WPS Series Quick Start Manual page 11

Quick Start Guide for the
WPS Series Wireless Pressure Sensor
1.6.1 Radio Frequency (RF) Statements
To comply with FCC's and Industry Canada's RF exposure requirements, the following antenna installation and device operating configura-
tions must be satisfied.
• Remote Point-to-Multi-Point antenna(s) for this unit must be fixed and mounted on outdoor permanent structures with a separa-
tion distance between the antenna(s) of greater than 20 cm and a separation distance of at least 20cm from all persons.
• Remote Fixed Point–to-Point antenna(s) for this unit must be fixed and mounted on outdoor permanent structures with a separa-
tion distance between the antenna(s) of greater than 20 cm and a separation distance of at least 100cm from all persons.
• Furthermore, when using integral antenna(s) the WPS Series Wireless Sensor unit must not be co-located with any other antenna
or transmitter device and have a separation distance of at least 20 cm from all persons.
1.6.2 European Union Restriction
The WPS Series Wireless Sensors are in conformity with the applicable portions of the ETSI standards as required by the R&TTE Directive
1999/5/EC.
Restriction
France restricts outdoor use to 10mW (10dBm) EIRP in the frequency range of 2,454 MHz to 2,483.5 MHz. Installations in France must limit
EIRP to 10dBm, for operating modes utilizing frequencies in the range of 2,454 MHz to 2,483.5 MHz.
50095585
ISSUE 1
Honeywell Sensing and Control 5