Table of Contents
Advertisement
User Manual for the
WPS Series Wireless Pressure Sensor
2.3.1 FCC Compliance Statements
•
This device complies with Part 15 of FCC Rules and Regulations. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
•
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in accordance
with these instructions, may cause harmful interference to radio communications. Operation of this equipment in a residen-
tial area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
•
Intentional or unintentional changes or modifications must not be made to the WPS Series Wireless Sensor unless under the
express consent of the party responsible for compliance. Any such modifications could void the user's authority to operate
the equipment and will void the manufacturer's warranty.
2.3.2 IC Compliance Statements
•
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropic radiated power (EIRP) is not more than that permitted for successful communication.
•
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must ac-
cept any interference, including interference that may cause undesired operation of the device.
•
This Class A digital apparatus complies with Canadian ICES-003.
•
French: Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
2.3.3 Radio Frequency (RF) Statements
To comply with FCC's and Industry Canada's RF exposure requirements, the following antenna installation and device operating con-
figurations must be satisfied.
•
Remote Point-to-Multi-Point antenna(s) for this unit must be fixed and mounted on outdoor permanent structures with a sepa-
ration distance between the antenna(s) of greater than 20cm and a separation distance of at least 20cm from all persons.
•
Remote Fixed Point–to-Point antenna(s) for this unit must be fixed and mounted on outdoor permanent structures with a sepa-
ration distance between the antenna(s) of greater than 20cm and a separation distance of at least 100cm from all persons.
•
Furthermore, when using integral antenna(s) the WPS Series Wireless Sensor unit must not be co-located with any other
antenna or transmitter device and have a separation distance of at least 20cm from all persons.
2.3.4 European Union Restriction
France restricts outdoor use to 10mW (10dBm) EIRP in the frequency range of 2,454 MHz to 2,483.5 MHz. Installations in France must
limit EIRP to 10dBm, for operating modes utilizing frequencies in the range of 2,454 MHz to 2,483.5MHz.
Restriction
France restricts outdoor use to 10mW (10dBm) EIRP in the frequency range of 2,454 MHz to 2,483.5 MHz. Installations in France must
limit EIRP to 10dBm, for operating modes utilizing frequencies in the range of 2,454 MHz to 2,483.5MHz.
4
Honeywell Sensing and Control
50095584
ISSUE 1
Advertisement
Table of Contents
