Table of Contents
Advertisement
Quick Start Guide for the
WPS Series Wireless Pressure Sensor
5.1.1 Connect Batteries
Perform the following just prior to connecting a sensor to the network.
The tools required:
•
#2 Phillips Screwdriver
•
Torque Screwdriver with #2 bit
Step
Action
WARNING
m
DO NOT DISASSEMBLE OR ASSEMBLE WHEN AN EXPLOSIVE ATMOSPHERE IS PRESENT
1
On the rear of the WPS Series sensor, Unscrew the four captive screws and remove the cover.
2
Remove the plastic battery insulator from the positive (+) terminal of on battery. Save this insulator for use when removing sen-
sors from the network, before storing them.
3
Verify that batteries are oriented with polarity as shown. Battery polarity is also shown on battery holder, underneath batteries.
4
Re-install the rear sensor cover and tighten screws to 1.5 N-m (13.2 inch-lbs.)
Figure 8. Battery Connection
20
Honeywell Sensing and Control
50095585
ISSUE 1
Advertisement
Table of Contents
