Table of Contents
Advertisement
User Manual for the
WPS Series Wireless Pressure Sensor
3
PREPARATION
3.1
Installation
Refer to the WPS Series Quick Start Guide (document 50095585) for installation and mounting of your WPS Series sensor.
Note: The sensors are shipped with batteries installed, but with an insulating tab at one battery terminal, so as to keep the sensor
inactive. This insulating tab must be removed prior to connecting to the network. (See Section 6)
3.2
Configuration
The WPS Series Sensor contains an electronics interface compatible for connecting to the
the
OneWireless WDM Interface
make up the sensor's configuration. These changes are written to the sensor when it is authenticated by a security key.
3.3
Connecting to Network
Use the
WDM User Interface
OW-CC0020
for procedures. Note that handheld provisioning devices are not applicable to the WPS Series Wireless Pressure Sensor.
3.4
Calibrating the Sensor
The WPS Series Wireless Pressure Sensor is factory calibrated at time of manufacture. The calibration parameters are permanently
stored in NVRAM in the measurement board. There is no user calibration routine available.
8
Honeywell Sensing and Control
to configure the sensor, to change operating parameters, and to create linkages between blocks that
to connect your sensor to the
OneWireless
network. Refer to the
50095584
ISSUE 1
OneWireless
network. An operator uses
Wireless Device Manager User's Guide
Advertisement
Table of Contents
