Advertisement
1. Safety Instructions
WARNING
Please keep this User Manual for future consultation. If you sell the fixture to another user, be
sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the fixture.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
Disconnect main power before servicing and maintenance.
Maximum ambient temperature is Ta: 40℃. Don't operate it where the temperature is higher
than this.
In the event of serious operating problem, stop using the fixture immediately. Never try to
repair the fixture by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always use the
same type spare parts.
Do not connect the device to any dimmer pack.
Do not touch any wire during operation and there might be a hazard of electric shock.
To prevent or reduce the risk of electrical shock or fire, do not expose the fixture to rain or
moisture.
The housing must be replaced if they are visibly damaged.
Do not look directly at the LED light beam while the fixture is on.
There are no user serviceable parts inside the fixture. Do not open the housing or attempt any
repairs by yourself. In the unlikely event your fixture may require service, please contact your
nearest dealer.
Due to the magnifying type lens, please keep the lens out of contact with direct sunlight. Direct
sunlight can cause heat to build up inside of the unit, which will seriously damage unit.
Please read the instructions carefully which includes important
information about the installation, operation and maintenance.
1A
Advertisement
