Epson PM-520 series User Manual page 21

User's Guide
3. Press the OK button.
4. Select Wi-Fi Setup Wizard, and then press the OK button.
5. Select the SSID for the access point from printer's control panel, and then press the OK button.
Note:
❏ If the SSID you want to connect to is not displayed on the printer's control panel, select Other Networks, and then
enter the SSID directly.
❏ If you do not know the SSID, check if it is written on the label of the access point. If you are using the access point
with its default settings, use the SSID written on the label.
6. After entering the password, move the cursor on Done and then press the OK button.
Note:
❏ The password is case-sensitive.
❏ If you do not know the password, check if it is written on the label of the access point. If you are using the access point
with its default settings, use the password written on the label. The password may also be called a "Key", a
"Passphrase", and so on.
❏ If you do not know the password for the access point, see the documentation provided with the access point, or
contact the person who set it up.
7. Check the settings, and then press the OK button.
8. Select whether or not you print a network connection report after finishing the settings.
If you fail to connect, load paper, and then press the
Related Information
"Checking the Network Connection Status" on page 25
&
"Cannot Make Network Connection Settings" on page 111
&
Making Wi-Fi Settings by Push Button Setup
You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Select Wi-Fi setup on the home screen, and then press the OK button.
2. Select Wi-Fi (Recommended), and then press the OK button.
3. Press the OK button.
4. Select Push Button Setup (WPS), and then press the OK button.
Network Settings
button to print a network connection report.
21