Average Parameters - IMKO SONO-VIEW Operating Instructions Manual

1.1.4 Average Parameters

Depending on the "average mode" set, various "average parameters" are available for control
purposes.
Average Mode
CA – Cyclic Average
CK – Cyclic Kalman
CF - Cyclic Floating
CC - Cyclic Cumulate
Note: Please also refer to the information in your Probe User's Manual.
Caution: Before you adjust a parameter, please be sure to check its function. A change can
affect the measured value, the accuracy and the measurement rate.
Page 24
Manual SONO-VIEW Version 3_1
Use the
Mode" and then set the mode as the default with the
button . The setting is then stored in the probe. Press
the button
Available Parameters
Average Time
Filter Upper Limit Offset
Filter Lower Limit Offset
Upper Limit Keep Time
Lower Limit Keep Time
Kalman with Boost
Average Time
Filter Upper Limit Offset
Filter Lower Limit Offset
Upper Limit Keep Time
Lower Limit Keep Time
Q-Parameter
R-Parameter
K-Parameter
Moisture Threshold
Boost
Offset
Average Time
Filter Upper Limit Offset
Filter Lower Limit Offset
Upper Limit Keep Time
Lower Limit Keep Time
Moisture Threshold
No Material Delay
/ buttons to set the desired "Average
to exit the "Average Mode" menu item.
2017-05-24