IMKO SONO-VIEW Operating Instructions Manual page 21

2017-05-24
In the next step, the tp value (radar signal time) has to be determined by a measurement with
the connected probe at the lower moisture point or by manual setting with pre-determined
tp values.
Measure:
See point „1.1.1.2.1
Set:
The next step is to determine the tp value (radar signal time), the upper moisture value, a
measurement (with the connected probe) or manual setting.
Manual SONO-VIEW Version 3_1
Subsequently, the percentage moisture value at the
lower point of the material to be measured, must be set
with the
the setting and press the button
previous item.
Use the
and "Set". The corresponding sub-point is selected with
the key
previous point.
1-Point Calibration(Measure)".
The tp value of the lower moisture point can be setted
manually using the
to accept the setting and press the button
the previous item.
The percentage reference moisture of the lower point of
the material to be measured, must then be set with the
/
and press the button
/ buttons. Press the button
/ buttons to toggle between "Measure"
and the key can be used to switch to the
/ buttons. Press the button
buttons. Press the button
to move to the previous item.
to accept
to move to the
to move to
to accept the setting
Seite 21