Curtis CFB3 User Manual page 15

CLEANING INSTRUCTIONS
Daily Cleaning (cont.)
Sanitizing
18 Fill a container with a sanitizer solution mixed in water (2% of sodium hypoclorite mixed in water).
19 Using a sponge dipped in sanitizing solution, sanitize the underside of the bottom portion of the lids. Allow 30
minutes for the solution to act.
20 Rinse the underside of the lid bottoms with a clean sponge soaked in fresh water. Place the lids on a clean
21 Thoroughly wash the bowl and drum with a sponge soaked in the sanitizer solution. Rinse thoroughly with
clean water.
22 Fill another container with sanitizer
solution and submerge the tap
parts, augers and seals in the
sanitizer solution. Leave them to
soak in the solution for 30 minutes.
Rinse thoroughly with clean water,
then air dry.
Reassemble the Unit
23 Install each auger seal on each
auger.
NOTICE: Failure to lubricate
seals may result in leaks.
24 Using food grade lubricant,
lubricate the inside of the auger
seal.
25 Reinstall the augers. Rotate each
auger until it engages completely.
26 Install a bowl seal on the back of
each bowl. The circular lip on the
on the seal.
27 Set the mixing bowls back in place.
Make sure that the lip on the bottom
of each bowl rests inside the front
trim on the top of the chassis.
28 Lubricate the tap mounting slots on
the front of each mixing bowl with
food grade lubricant.
continued...
FROZ BEV DISP, CLEANING INSTRUCTIONS
23
Groove
25
27
CI31
24
Lip
26
28
082418A