Curtis CFB3 User Manual page 14

CLEANING INSTRUCTIONS
Daily Cleaning (cont.)
Remove the Mixing Bowls and Lids
8 Remove the handle assemblies
from the bowl taps by pushing in
on the top of the handle with your
thumb while pulling up on the
9 Disconnect the lid light plugs from
the sockets behind the mixing bowl.
Make sure that the plugs do not
come into contact with liquids while
removed.
10 Lift off the lids. Raise the front part
of each bowl to release. Remove
each bowl from its seat by pushing
and tapping lightly on the rear.
11 Pull the bottom part of the lids free
from the top part.
NOTICE: To prevent damage,
DO NOT immerse the top
any kind.
12 Pull forward on each auger to
remove it from the drum. Remove
the auger seal.
13 Pull the bowl seal off of the back of
the bowl.
14 Inspect all auger, bowl and
tap seals. Replace all worn or
damaged seals with new ones.
NOTICE: Failure to replace
worn seals may result in leaks.
Clean the Mixing Bowl Parts
15 Soak the bottom part of the lids, removed in step 11, and the tap parts and auger in the detergent solution and
scrub with a soft cloth. Rinse in fresh water.
16 To clean the top portions (lighted part) of the lids, use a clean, damp cloth soaked with detergent solution.
Using a clean, damp cloth, wipe clean the outside portion of the lid top. Wipe with a clean, damp cloth soaked
in fresh water.
17 Clean the mixing bowls and drums with a clean damp cloth soaked with detergent solution. Wipe with a clean,
damp cloth soaked in fresh water.
FROZ BEV DISP, CLEANING INSTRUCTIONS
Auger
seal
continued...
8
10
12
CI31
9
11
13
082418A