Table of Contents
Advertisement
Jointer/planer
conversion
the model g0634z/g0634Xp is ready for jointer
operations after it is first setup. to use the
machine as a planer, you must convert it from a
jointer to a planer.
to convert the machine for planer operations:
1.
disConneCt maChine From power!
2.
g0634z: loosen quick release knobs (see
figure 37) and slide fence off of machine.
Quick-release
knobs
figure 37. location of quick-release knobs
(g0634z).
3.
g0634zXp: loosen fence lock lever, slide
fence toward front of machine, carefully slide
protective flap through bracket, and lift fence
off of fence rail (see figure 38).
Fence lock
lever
Fence rail
Bracket
figure 38. Fence removal components
(g0634Xp).
Model G0634Z/G0634XP (Mfd. Since 01/11)
protective Flap
4.
remove dust hose from jointer dust port.
5.
rotate infeed table lock lever (figure 39)
clockwise, pull it out, and pivot table upward.
the table will lock into place when raised to
its highest position, as shown in figure 40.
table lock
lever
figure 39. example of infeed table lock lever.
figure 40. example of infeed table pivoted up.
6.
raise outfeed table in same manner as you
did with infeed table.
-37-
Advertisement
Table of Contents
