Replacing Carbide Inserts - Grizzly G0634XP Owner's Manual

replacing carbide
inserts
items needed:
t-handle wrench w/t-20 torx Bit ..................... 1
the cutterhead is equipped with 56 indexable car-
bide inserts. each insert can be rotated to reveal
any one of its four cutting edges. therefore, if
one cutting edge becomes dull or damaged,
simply rotate it 90˚ to reveal a fresh cutting
edge (figure 79).
figure 79. insert rotating sequence.
Model G0634Z/G0634XP (Mfd. Since 01/11)
Qty
reference dot
in addition, each insert has a reference dot on
one corner. as the insert is rotated, the reference
dot location can be used as an indicator of which
edges are used and which are new. when the
reference dot revolves back around to its starting
position, the insert should be replaced.
to rotate or change a carbide insert:
1. disConneCt maChine From power!
2. remove any sawdust from the head of the
carbide insert torx screw.
3. remove the torx screw and carbide insert.
4. Clean all dust and dirt off the insert and the
cutterhead pocket from which the insert was
removed, and replace the insert so a fresh,
sharp edge is facing outward.
note: Proper cleaning is critical to achieving
a smooth finish. Dirt or dust trapped between
the insert and cutterhead will slightly raise the
insert, and make noticeable marks on your
workpieces the next time you plane.
5. lubricate the torx screw threads with a
light machine oil, wipe the excess oil off the
threads, and torque the torx screw to 48-50
inch/pounds.
note: Excess oil may squeeze between the
insert and cutterhead, thereby lifting the insert
slightly and affecting workpiece finishes.
-55-