Table of Contents
Advertisement
to set the 45° fence stop:
1.
loosen the fence tilt knob and position the
fence against the 45° stop bolt.
2.
loosen the lock nut on the 45˚ fence stop
screw (see figure 85).
45° stop screw
lock nut
figure 85. adjusting fence 45˚ outward.
3.
adjust the 45˚ stop screw until the fence is
exactly 45° outward while resting on the bolt
(check the angle with a sliding bevel set to
135° or with a 45° square).
4.
re-tighten the lock nut loosened in step 2.
-58-
adjusting table lock
levers
the table lock levers can be adjusted if they do
not lock.
items needed
wrench 14 mm .................................................. 1
to adjust the table lock levers:
1.
disConneCt maChine From power!
2.
remove the cutterhead guard.
3.
raise the table on the side of the lock lever
that does not lock.
4.
loosen the lock nut on the special bolt under
the table, as shown in figure 86.
figure 86. table lock lever bolt.
5.
adjust the bolt height a few turns, lower the
table, and try engaging the lock lever.
6.
repeat steps 3-5 until the lever engages,
then secure the lock nut.
Model G0634Z/G0634XP (Mfd. Since 01/11)
Qty
special
Bolt
lock nut
Advertisement
Table of Contents
