Table of Contents
Advertisement
adjusting gibs
the function of the table gibs is to eliminate
excessive play in the table movement. the gibs
also control how easy it is to move the tables.
tools needed
adjustable wrench ........................................... 1
hex wrench 8mm .............................................. 1
to adjust the table gibs:
1.
using an adjustable wrench, loosen the
infeed table gib nut under the rear of the table
(figure 87).
gib set screw
figure 87. infeed table gib control.
2.
using an 8mm hex wrench, tighten the gib set
screw a small amount, then check the table
by moving it up and down. adjust the set
screw as needed until the friction of the table
movement is balanced between minimal play
and ease of movement, then secure the gib
nut.
note: Tighter gibs reduce play but make it
harder to adjust the tables.
Model G0634Z/G0634XP (Mfd. Since 01/11)
Qty
gib nut
3.
repeat steps 1-2 with the outfeed table gib
control (figure 88).
gib nut
figure 88. outfeed table gib control.
4.
set the outfeed table height as described in
setting outfeed table height on page 24.
gib set screw
-59-
Advertisement
Table of Contents
