Motor Cable - Viking X-9S Installation Instructions And Safety Information

ELECTRICAL INSTALLATION
Motor Cable - Master (Single)
NOTE:
The Single Electronic Control Unit (VA-ECUSNX) is equipped to operate a single
gate motor only, and does not include a Slave Module. The steps described on page 23
do not apply for this type of application.
STEP 3
Master Motor:
a. Connect motor cable to the Motor
Connector at the Master Control
Board as illustrated, according to
the printed color code.
STEP 4
Master Open Left or Open Right:
Place the terminal block in the proper location for the gate opening direction.
• "OPEN RIGHT" Connector if the gate opens Inside to the Right or Outside to the Left.
• "OPEN LEFT" Connector if the gate opens Inside to the Left or Outside to the Right.
2 2
VIKING TECHNICAL SUPPORT 1.800.908.0884
3a
3b