Viking X-9S Installation Instructions And Safety Information page 45

UL ADV Feature
IMPORTANT REQUIREMENTS:
• The installed sensor MUST be "10K Resistor Based".
• Only use this feature if
to reverse the gate all the way to the OPEN LIMIT position.
STEP 1
Connect the Monitored Sensor to the Viking control board input terminals "UL" and
"GND" as illustrated.
STEP 2
Turn ON the UL ADV
Feature:
• Toggle the "Diagnose"
button until you see
on the LCD Display.
• Default setting is OFF.
• Press and hold the "Stop"
button.
• Toggle the "Diagnose"
button once.
• The feature should now be
displayed as "ON".
10K (Sensor's Monitored Terminals)
24VDC (may not be required on all sensors)
VIKING TECHNICAL SUPPORT 1.800.908.0884
ALL sensors connected to the UL input terminal are desired
UL ADV
Appendix (C)
UL ADV
UL LEARN
OFF
SENSOR 1
4 3