Installation Of Alarm; Local Sensor Only; Standing Pressure Test; Frame/Module Assembly - Amico Alarm Valve Combo Unit Installation And Maintenance Manual

Installation of Alarm

For Local Sensor Only
If the sensors are to be mounted locally (inside the valve box), the pipe stubs must be connected to the
pipeline. Using silver-brazing techniques, connect each pipe stub to its appropriate gas or vacuum while
ensuring that the bottom of the pipe stub is wrapped with a damp cloth. BE CAREFUL not to damage the DISS
check-valve by overheating. When the brazing of pipe stubs has been completed, the system can be pressure
tested.

Standing Pressure Test

Perform a standing pressure test on the piping system as per NFPA-99 "Health Care Facilities" or
CSA-Z305.1 "Non-flammable Medical Gas Piping Systems". Inspect all joints for leaks and make certain each gas
is piped to a correspondingly labeled gas service.

Frame/Module Assembly

Step #1 Remove the frame/valve window from its protective box
Step #2 Attach the Sensor wire to the display module (Sensor +, -)
Step #3 Close the valve window
9
www.amico.com