Annunciator Module; Noise Level Control; Control Of Remote Alarm Buzzer - Amico Alarm Valve Combo Unit Installation And Maintenance Manual

FIELD ADJUSTMENTS
To decrease noise level:

Annunciator Module

1.
THE ANNUNCIATOR MODULE

NOISE LEVEL CONTROL

Noise Level Control
Factory Default: 80 Decibels
Factory Default: 90 Decibles
To decrease noise level:
To decrease noise level:

CONTROL OF REMOTE ALARM BUZZER

1. Locate jumper at J5. Move jumper to:
1.
LVL1 = 90 dBa.
Factory Default: Normal Condition
LVL2 = 80 dBa.
LVL3 = 70 dBa.
To silence remote alarm buzzer when silencing the
annunciator module:
Control of Remote Alarm Buzzer
1.
Factory Default: Normal Condition
CONTROL OF REMOTE ALARM BUZZER
To silence remote alarm buzzer when silencing the annunciator module:
1. Locate jumper at J6. Move jumper to: Factory Default: Normal Condition
NORM =
To silence remote alarm buzzer when silencing the
Remote alarm buzzer will silence when annunciator module is silenced.
annunciator module:
1.
ALRM =
Remote alarm will not silence when annunciator module is silenced.
The buzzer will only silence when an alarm condition has been cleared.
Please refer to Appendix B.
Steps to Re-Calibrate the Sensor from Area Module v4.0
P a g e : 1 6
1. Turn on Alarm
2. Set switches #8 and #10 the OFF position
3. Set switches #5 and #6 the ON position
4. The display will show the current reading of the pressure
P a g e : 1 6
5. Adjust the calibration, using the "UP" and "DOWN" push buttons, to the desired value.
6. Set switches #5 and #6 the OFF position
7. Turn on #10 if AIMS is connected (do not turn on #8)
When you have completed step #7, the display module will automatically go into "RESET" mode. This will store
the data that you entered.
12 Amico Corporation
Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence
Locate jumper at J6. Move jumper to:
when alarm condition has been cleared. Please
refer to Appendix B.
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence
when alarm condition has been cleared. Please
refer to Appendix B.
LVL1
LVL2
LVL3
SILENCE
LVL1
LVL2
LVL3
SILENCE
ALRM
NORM
TEST
ALRM
NORM
TEST