Precautions For Correct Use - Omron V600 Series User Manual

Please observe the following precautions to prevent failure to operate, malfunctions, or undesirable effects on product
performance.
1. Installation Location
Do not install the product in the following locations:
• Locations subject to corrosive gases, dust, dirt, metal powder, or salt
• Locations where the specified ambient operating temperature range is exceeded
• Locations subject to extreme temperature changes that may result in condensation
• Locations where the specified ambient operating humidity range is exceeded
• Locations where the product would be directly subjected to vibration or shock exceeding specifica-
tions
• Locations subject to contact with water, oil, or chemicals
2. Installation
• The product uses the 530-kHz frequency band to communicate with Data Carriers. Some devices,
such as some motors, inverters, and switch mode power supplies, generate electromagnetic waves
(i.e., noise) that can affect communications with the Data Carriers. If any of these devices are nearby,
communications with Data Carriers may be affected or Data Carriers may be destroyed.
If the product is to be used near such devices, check the effects on communications before using the
product.
• To minimize the general influence of noise, follow the following precautions:
(1) Ground any metallic material located around the product to 100 W or less.
(2) Keep product wiring away from high voltage or heavy current.
• The product does not provide a water-proof structure. Do not use it where mists are present.
• Do not use chemicals that will affect product materials.
• Tighten screws to 1.2 N·m maximum when mounting the product.
• Communications performance may be reduced due to mutual interference if more than one Read/
Write Head is installed in the same vicinity. Refer to the Read/Write Heads and SRAM Data Carriers
Operation Manual (Cat. No. Z127) and Read/Write Heads and EEPROM Data Carriers (Cat. No.
Z128) and confirm that there is no mutual interference between Read/Write Heads.
3. Storage
Do not store the product in the following locations:
• Locations subject to corrosive gases, dust, dirt, metal powder, or salt
• Locations where the specified ambient operating temperature range is exceeded
• Locations subject to extreme temperature changes that may result in condensation
• Locations where the specified ambient operating humidity range is exceeded
• Locations where the product would be directly subjected to vibration or shock exceeding specifica-
tions
• Locations subject to contact with water, oil, or chemicals
4. Cleaning
• Do not use thinners for cleaning. Resin materials and the case coating will be dissolved by thinners.

Precautions for Correct Use

Preface
RFID System
7
Operation Manual