User Interface Summary; Starting The Pump - Hayward PowerFlo VS 300 Owner's Manual

3.9. User Interface Summary

▾
1. Button "1/
2. Button "2/OK": used to select the fixed MEDIUM speed or to confirm/save parameters while in the
programming mode.
▴
3. Button "3/
4. LED display window: displays the current speed of the motor, or error code message.
5. "SET" button: used to enter the programming mode or to reset the control.
6. Button "O": used to STOP the motor.
7. Error light: illuminates when there is a fault detected.
8. Power light: illuminates when power turns on.

3.10. Starting the pump

To start the pump press the button "1", "2" or "3" to select the preset fixed speed. If the pump starts from standby
mode, it starts up and subsequently runs with the selected fixed speed.
The default speed settings are as follows.
Speed 1 = 1600 rpm
Speed 2 = 2600 rpm
Speed 3 = 3400 rpm
The pump will automatically change from selected speed "3" to speed "1" after 2 hours of run time.
The pump will automatically change from selected speed "2" to speed "1" after 24 hours of run time.
Page 9 of 20
": used to select the fixed LOW speed or to decrease speed while in the programming mode.
": used to select the fixed HIGH speed or to increase speed while in the programming mode.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
PowerFlo VS Variable Speed Pump
Figure 3.9-1
IS1580X15VSP Rev-A