User Interface Summary - Hayward IS3206VSP3 Owner's Manual

6.3. User Interface Summary

Preset Speeds: Buttons labeled SPEED 1 thru SPEED 4 can be used to run the pump at a predetermined speed
1.
until the next programmed timer is scheduled to begin. Preset Speed settings can be quickly updated using the
+ and - arrow buttons to change the speed and then pressing the > button to save the new speed setting if
desired.
a. Default Speeds:

Speed 1: 1150 rpm

Speed 2: 1725 rpm

Speed 3: 2300 rpm

Speed 4: 2875 rpm
2. Menu/navigation buttons: The MENU button will scroll through the setup menus when pressed. The < and >
arrow buttons are used to move between displays and to select parameters to edit, and the + and - arrow
buttons are used to change parameters.
3. Stop/Resume: This button is used to stop the pump to allow strainer basket cleaning, etc. When this button is
pressed, the pump will remain stopped until the button is pressed a second time to resume normal operation.
4. Quick Clean: QUICK CLEAN is a mode intended for use when the pool will be cleaned with a suction side
vacuum. While in Quick Clean mode, for SVRS pump models, the SVRS feature is disabled for 60 minutes to
prevent nuisance tripping during cleaning. Users will be prompted to check and verify that all bathers are out of
the pool during this time.
Page 20 of 36
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2.70 THP VS Pump Family
Figure 6.3-1
IS3206VSP3 Rev-A