User Interface Summary - Hayward LifeStar VS Owner's Manual

6.3. User Interface Summary

1. Preset Speeds: Buttons labeled SPEED 1 thru SPEED 4 can be used to run the pump at a
predetermined speed for a certain length of time. Preset Speed settings can be quickly updated using
the + and - arrow buttons to change the speed and then pressing the > button to save the new speed
setting. When a speed is selected, the LED beside the button will illuminate to indicate operation.
a. Default Speeds:
 Speed 1: 1000 rpm
 Speed 2: 1750 rpm
 Speed 3: 2500 rpm
 Speed 4: 3250 rpm
2. Menu/navigation buttons: The MENU button will scroll through the setup menus when pressed.
The < and > arrow buttons are used to move between displays and to select parameters to edit, and
the + and - arrow buttons are used to change parameters.
3. Status LEDs: The CHECK SYSTEM LED will illuminate when the pump is experiencing an error
condition. The TIMERS ACTIVE LED will illuminate once timers have been programmed to run
the pump, even if the pump is not presently running.
4. Stop/Resume: This button is used to stop the pump to allow strainer basket cleaning, etc. When
this button is pressed, the pump will remain stopped until the button is pressed a second time to
resume normal operation. When the pump is stopped, the red LED beside the button will illuminate
to indicate that the pump has been stopped.
5. Quick Clean: QUICK CLEAN is a mode intended for use when the water vessel will be cleaned
with a suction side vacuum.
_____________________________________________________________________________________
Hayward Flow Control
Figure 6.3-1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
www.haywardflowcontrol.com 1-888-HAY-INDL (1-888-429-4635)
IS3401VSPFC Rev A 12/08/14
Pg. 19 of 36