Setting Watering Start Times; Setting The Run Times - Hunter NODE-100 Owners Manual And Programming Instructions

PROGRAMMING (CONTINUED)
6 . All four numbers are shown with the two numbers on the left
flashing, representing the hour. Use the
change the hour. Press the
the minutes.
7 . All four numbers are shown with the two numbers on the right
flashing, representing the minutes. Use the
change the minutes. Pressing the
to the year setting at Step 2.
8 . Press the button to proceed to the next programming function
or allow controller to return to idle mode.

Setting Watering Start Times

1 . Press the button until the
2 . The start time will be displayed flashing, along with the program
letter (A, B, or C) and the start time number (1, 2, 3, or 4) in the
upper left of the display. Up to 4 different start times can be set for
each program.
3 . Use the or buttons to change the start time for the program
that is displayed. Each press of the button will change the start
time in one-minute increments.
4 . Press the button to add an additional start time to the program
displayed. The start time number is shown in the upper left corner
of the display.
5 . Press the button to add start times to a different program.
6 . Press the button to proceed to the next programming function
or allow controller to return to idle mode.
or buttons to
button to proceed to setting
or buttons to
button will advance
icon is displayed.
NOTE: After programming the run time for the last
station press the
time for the program.

Setting the Run Times

1 . Press the button until the
2 . The run time will be displayed flashing. Also shown is the program
letter (A, B, or C) and the active station number on the lower
left side of the display. Press the
station run time from one minute to six hours.
3 . Press the button to advance to the next station.
4 . Press the button to add a run time to another program.
5 . Press the button to proceed to the next programming function
or allow controller to return to idle mode.
button to display the total run
icon is displayed.
or buttons to change the
EN
8