Setting Watering Start Times; Setting The Run Times - Hunter Node Owner's Manual

PROGRAMMING (CONTINUED)
6 . All 4 numbers are shown with the two numbers on the left
flashing, representing the hour . Use the
change the hour . Press the
the minutes .
7 . All 4 numbers are shown with the two numbers on the right
flashing, representing the minutes . Use the
to change the minutes . Pressing the
to the year setting at step #2 .
8 . Press the button to proceed to the next programming
function or allow controller to return to idle mode .

Setting Watering Start Times

1 . Press the button until the
2 . The start time will be displayed flashing, along with the
program letter (A, B, or C) and the start time number (1, 2, 3,
or 4) in the upper left of the display . Up to 4 different start
times can be set for each program .
3 . Use the or buttons to change the start time for the
program that is displayed . Each press of the button will change
the start time in 15 minute increments .
4 . Press the button to add an additional start time to the
program displayed . The start time number is shown in the
upper left corner of the display .
5 . Press the button to add start times to a different program .
or buttons to
button to proceed to setting
or buttons
button will advance
icon is displayed .
6 . Press the button to proceed to the next programming
function or allow controller to return to idle mode .
NOTE: After programming the run time for the
last station press the
total run time for the program.

Setting the Run Times

1 . Press the button until the
2 . The run time will be displayed flashing . Also shown is the
program letter (A, B, or C) and the active station # on the lower
left side of the display . Press the
the station run time from 1 minute to 6 hours .
3 . Press the button to advance to the next station .
4 . Press the button to add a run time to another program .
5 . Press the button to proceed to the next programming
function or allow controller to return to idle mode .
ENG
button to display the
icon is displayed .
or button to change
8